User's Manual

Recall Filter setting screen Chapter 6. Presets
MTX Editor User’s Manual
137
•[MY4-AEC] button
If this is on, the settings of the MY4-AEC installed in the MTX5-D will be recalled.
This is not shown if the MY4-AEC is not selected in the “Device Configuration
Wizard.”
The following settings are outside the recall settings of the [MY4-AEC] button.
• From Far-end, Far-end Voice, Near-end Mic., Near-end Voice, and To Far-end
(included in the [IN PATCH] button range)
•SRC
■ [External I/O] tab
Here you can choose the external device parameters for which to make Recall Filter
settings.
● [All On] button
Turns on (blue) all of the buttons of the currently selected tab. All parameters will be
recalled.
● [All Off] button
Turns off (white) all of the buttons of the currently selected tab. None of the parameters
will be recalled.
● Parameter select buttons
The parameter select buttons are shown for each device (UNIT ID, device name). If
these buttons are on, the parameters included in the buttons will be recalled for each
channel. The [PWR] button corresponds to the power on/standby status of the device,
and the alphabetical or numeric buttons correspond to the channels of each device.