User's Manual
“IP Address” dialog box Chapter 7. Dialog boxes
MTX Editor User’s Manual
144
“IP Address” dialog box
Here you can specify the device’s IP address and subnet mask.
Normally, you will set the “IP SETTINGS” DIP switch of all devices to “UNIT ID.” We
recommend that you set the computer’s IP address to “192.168.0.253” and the subnet mask
to “255.255.255.0”.
Editing is not possible while online.
If a PIN code has been assigned, you will be asked to enter the PIN code.
If you want to change the device’s IP address and subnet mask, make the following settings
in this dialog box.
1. In the “IP Address” dialog box, choose the [DHCP] option button
(connect to a DHCP server) or the [Use the following IP Address] option
button (specify a fixed IP address for the device).
2. If you are specifying a fixed IP address, specify the values in [IP address]
and [Subnet Mask].
3. Click the [OK] button.
4. Turn off the power of the device.
5. On the rear panel of the device, set DIP switch 6 ON (PC mode).
6. Turn on the power of the device.
7. In the “Device Information” dialog box, click the [Refresh] button.
Verify that the device’s IP address has been changed.
● Current Settings
The UNIT ID and IP Setting specified by the device’s rear panel DIP switch are shown
here.
● UNIT ID
If the device’s rear panel DIP switch IP Setting is “UNIT ID,” the IP address and subnet
mask are shown here.
NOTE