User's Manual

“MTX Configuration” dialog box Chapter 7. Dialog boxes
MTX Editor User’s Manual
147
● [OUTPUT] tab
In this tab, you can make settings related to outputs.
•MATRIX BUS SETUP
Here you can make settings for the matrix buses. These settings will affect the
“MATRIX” screen.
MONO x2...............The input channels will be treated as two monaural channels.
STEREO .................The input channels will be treated as a single stereo pair.
If the MTX system’s YDIF mode is Cascade mode, the parameters will be shared in
common by all MTX units in the MTX system.
• CASCADE MODE
Here you can specify the zone input source for each matrix. This setting cannot be
made in Distribution mode.
• OUTPUT CHANNEL SETUP
Here you can specify the type of output channel speaker processor (1WAYx2 or
2WAY). The settings here will affect the channel strip of the “MAIN” screen.
On Off
The matrix out of all MTX units will
be mixed for each matrix. That mixed
signal will be used as the input to the
zone.
Instead of using the mix from the bus,
the matrix out will be used as the
input for the zone.
NOTE
BUS1 BUS2
01 MTX3
Matrix1
ZONE1
02 MTX3
Matrix1
ZONE1
03 MTX3
Matrix1
ZONE1
04 MTX3
Matrix1
ZONE1
BUS1 BUS2
01 MTX3
Matrix1
Local Mix
ZONE1
02 MTX3
Matrix1
ZONE1
03 MTX3
Matrix1
ZONE1
04 MTX3
Matrix1
ZONE1