User's Manual

Workflow Chapter 1. An overview of MTX Editor
MTX Editor User’s Manual
21
Connect the devices and your computer as shown in the configuration diagram.
Connect the device to the computer using its [Dante] connector for a Dante-equipped unit
or its NETWORK connector for a YDIF-equipped unit. Normally you will connect the
devices to the computer via a network switch. Only in the case of Dante-equipped models
when using a daisy-chain connection, you will connect the units to the computer in a
daisy-chain. If there is only one MTX unit, you can also connect the computer directly to
the MTX.

Turn on the power of the device.

Select the network card and specify the IP address of the computer.
To select the network card, use the “Network Setup” dialog box which you can access from
the [System] menu. If no DHCP server is connected, set the IP address of the network card
to a fixed IP address. The IP address setting for the network card is made in Control Panel
“Network Connections.” You can access “Network Connections” by clicking the [Open
Network Connections] button in the “Network Setup” dialog box.
When connections have been established between the computer and the devices, the
device icons shown in the Project screen will change.
Verify that the firmware versions of the devices are compatible with MTX
Editor.
For details, refer to the “Device Information” dialog box which you can access from
the [System] menu.
For information about firmware compatibility with MTX Editor, refer to the Yamaha
Pro Audio website.
http://www.yamahaproaudio.com/japan/ja/

NETWORK connector of
the MTX3
NETWORK connector of a
YDIF-equipped model of XMV
[Dante] connector of a Dante-
equipped model of XMV
[Dante] connector of
the MTX5-D
NETWORK connector of
the EXi8/EXo8
Connections with the
devices has succeeded