User's Manual

Data handled by MTX Editor Chapter 1. An overview of MTX Editor
MTX Editor User’s Manual
6
Data handled by MTX Editor
Even if you modify the configuration, the changes will not be reflected in previously-stored
presets. After modifying a configuration, you must (if necessary) recall the preset and then
store it again.
Project file (.mtx)
Configuration
Device structure
*1
The type and number of devices, their UNIT ID, and YDIF connection order
MTX system settings
*2
YDIF mode
Device name
“Preset” dialog box
“Security Setting” dialog box ([File] menu)
“Project Information” dialog box ([File] menu)
Contents of “Set IP Address” in the “Device Information” dialog box ([System]
menu)
“MTX Configuration” dialog box ([System] menu)
“Daylight Saving Time” dialog box ([System] menu)
“Scheduler” dialog box ([System] menu)
“GPI” dialog box ([System] menu)
“Remote Control” dialog box ([System] menu)
Library of the “Digital Control Panel” dialog box ([Controller] menu)
Library of the “Wireless DCP” dialog box ([Controller] menu)
Dimmer on/off ([Device] tab)
Patching in the “EXT. I/O” screen between the MTX and external devices (YDIF
connections, analog connections, Dante connections)
*1 Synchronization is not possible if the device configuration is different.
*2 This will not change even if the preset is switched.
Preset
MTX sources for YDIF in the “EXT. I/O” screen
Parameters for MTX components
Assignments to DCP library presets
Assignments to Wireless DCP library presets
GPI Out status
[SD Song Select & Play]
Parameters of external devices
MY4-AEC parameters (except for AES/EBU)
Speaker Processor Library (.ce3)
NOTE