User's Manual

“ZONE” screen Chapter 4. System screen
MTX Editor User’s Manual
79
1 ZONE select buttons
Use the left and right buttons to select the zone for which to make settings.
The name of the zone is shown at the right.
You can also use the output channel [SEL] buttons to select a zone.
2 Graph and GR meter
This graph shows the ducker settings. The amount of gain reduction applied by the
ducker is shown at the right of the graph.
Use the [1st PRIORITY] and [2nd PRIORITY] tabs to switch the display between the
duckers.
3 Ducker setting area
Ducker settings can be copied between 1st/2nd, or to
another zone.
When you right-click within the copy-source settings area,
a list will appear.
• DUCKER [ON] button
Turns the ducker on/off.
• [PRIORITY SOURCE] list
Selects the input signal for the ducker.
•DUCKER indicator
When the ducker operates, the indicator will light green to indicate operation.
• [MIX LEVEL] knob
Adjusts the amount by which the signal selected in the [PRIORITY SOURCE] list
will be mixed into the ducker’s output.
•[THRESHOLD] knob
Specifies the threshold level at which the ducker will take effect.
•[RANGE] knob
Specifies the amount of attenuation applied when the ducker is active.
This amount specifies how much of the main audio will remain, or whether it will
be silenced.
•[ATTACK] knob
Specifies the time from when the priority source input signal exceeds the
THRESHOLD until the ducker for the main signal reaches the amount of
attenuation specified by the [RANGE] knob.
•[HOLD] knob
Specifies the time from when the input signal falls below the THRESHOLD until the
signal begins returning to its original level.
•[RELEASE] knob
Specifies the duration of the wait from when the HOLD time has elapsed until the
ducker no longer affects the input signal.
4 ANC setting area
•ANC [ON] button
Turns ANC on/off.
•[AMBIENT SOURCE] list
Selects the channel to which the ambient noise detection mic is connected.
• [AMBIENT THRESHOLD] knob
Specifies the average level of ambient noise.
NOTE
HINT