User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
110
Play back a pre-recorded message from SD card
1.
Use the zone/message select buttons to select the broadcast area.
2.
Use the zone/message select buttons to select the message that you want to play back.
3.
Press the PTT button.
If specified, the Opening Chime is heard.
The message plays, and the status indicator is lit red.
When message playback is completed, PTT automatically turns off.
If specified, the Closing Chime is heard.
Use the scheduler to play back a pre-recorded message from SD card
By issuing a Paging event, the specified message is played back to the specified zone or zone group.
Using the Device Configuration Wizard to create your device setup
Before you specify the internal configuration of the MRX, use MTX-MRX Editor’s wizard to create the device configura-
tion.
After you’ve made basic settings, you’ll be able to print information about the cabling and ID numbers.
Use the following procedure to make basic settings.
1.
Type a name for the MTX/MRX system you’ll be constructing, and click [Next>].