User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 1) Ballroom where the Room Combiner can be used
MRX Setup Manual
14
2.
Connect the space between the ports from “HPF” to “Auto Gain Control” by dragging
and dropping.
3.
Select the area between “HPF” and “Auto Gain Control”, so that the components and
wires are selected.
4.
Copy the selected components and wires and paste twice, or drag and drop the
selected components and wires while holding down <Ctrl>.
Change the placement of the components as need be.
Here’s how to copy:
• <Ctrl> + <C>
• Right-click and select [Copy] from the context menu
• Select [Copy] from the [Edit] menu
Here’s how to paste:
• <Ctrl> + <V>
• Right-click and select [Paste] from the context menu
• Select [Paste] from the [Edit] menu