User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 2) Remote conferencing system that also uses Speech Privacy
MRX Setup Manual
89
In this example, we’ll see how to make it easier to operate in ProVisionaire Touch, such as by assigning a single fader to
two faders for stereo output to conference room speakers, or by assigning a single button to activate all of the mic ON but-
tons.
Here we’ll create a parameter link group that links multiple parameters such as levels or ON/OFF, so that we can change
multiple parameters at the same time with a ProVisionaire Touch fader or button.
1.
Open the “Parameter Link Group” area on the left side of the MRX Designer, in order to
check the parameters that are registered.
Setting a parameter link group