User Manual

Configuring the device
Yamaha LAN Monitor for Win User Guide
36
NOTE
Some items will not be displayed until the firmware revision is acquired.
If some items are not displayed, please wait for a while and then open the Device Settings dialog again.
 For the SWX2110/SWX2110P/SWX2200 series Yamaha switch
Use this to view or change the settings.
The tabs shown at the top of the dialog allow you to switch between information displays.
• [Switch settings] tab: View or configure the settings of the Yamaha switch.
• [Port settings] tab: Configure basic functions, VLAN, and other settings for each port.
Switch settings
Of the following items, only the setting items marked with ✓ are displayed.
“Device name
settings”
Click the [Set] button to display the “Device name settings” dialog.
The device name you set in “Device name settings” will be saved in the device itself.
“IP address settings”
Click the [Settings] button to display the “IP address settings” dialog box.
[Update firmware from
PC] button
Click the [Update firmware from PC] button to display the “Update firmware from PC”
dialog box.
“Config Import/Export”
Click the [Import] button to display the “CONFIG import” dialog.
Click the [Export] button to display the “CONFIG export” dialog.
[Close] button
When you click this, the “Device Settings” dialog box closes.
This item will be displayed for all devices.
Items
SWX2110/
SWX2110P
series
SWX2200
series
Descriptions
Device name
✓✓
Changes the device name.
Click the [Settings] button to display the “Device name”
dialog box.
Label
✓✓
Allows you to enter a label that distinguishes the
individual device.
Click the [Settings] button to display the “Label” dialog
box.
Comment
✓✓
Allows you to enter a comment.
Click the [Settings] button to display the “Comment”
dialog box.
Snapshot ✓✓
Cannot be changed. This is fixed to “On.”