User Manual

Wireless DCP Owner’s Manual
10
3. Configuration
 Key points for network configuration
1. The devices to be connected must have IP addresses from the same network (or subnet).
*: If using a Wi-Fi access point that is not also a router, set the IP address for accessing it.
2. Eight smart devices running Wireless DCP can be connected to each MTX processor. (However, only one
device can be logged into with an administrator PIN.)
3. Connect the MTX processor to the LAN connector of the Wi-Fi access point.
If you connect to a WAN (Internet) connector, the smart device will not be able to communicate properly with
the MTX processor.
Good combination of settings
Incorrect combination of
settings
Router with integrated Wi-Fi*
and DNS
192.168.0.254 192.168.11.1
MTX processor 192.168.0.1 192.168.0.1
Smart device 192.168.0.200 192.168.11.50
Computer 192.168.0.253 192.168.0.253
Smart device
Wi-Fi access point
Computer
MTX processor