User Manual

Configuring the device
Yamaha LAN Monitor for Mac User Guide
37
NOTE
Some items will not be displayed until the firmware revision is acquired.
If some items are not displayed, please wait for a while and then open the Device Settings dialog again.
 For the SWX2110/SWX2110P series Yamaha switch
Use this to view or change the settings.
The tabs shown at the top of the dialog allow you to switch between information displays.
• [Switch settings] tab: View or configure the settings of the Yamaha switch.
• [Port settings] tab: Configure basic functions, VLAN, and other settings for each port.
[Include in a snapshot]
check box
Turns the snapshot function on/off for each device. For a slave device, this is fixed on.
This item will be displayed for all devices.
“Label Settings”
You can enter any label or comments you like to identify each device.
Since the labels and comments you set will only be used within LAN Monitor, this
information can be associated with the device without changing the settings of the device
itself.
This item will be displayed for all devices.
“Device name
settings”
Click the [Set] button to display the “Device name settings” dialog.
The device name you set in “Device name settings” will be saved in the device itself.
“IP address settings”
Click the [Settings] button to display the “IP address settings” dialog box.
[Update firmware from
PC] button
Click the [Update firmware from PC] button to display the “Update firmware from PC”
dialog box.
“Config Import/Export”
Click the [Import] button to display the “CONFIG import” dialog.
Click the [Export] button to display the “CONFIG export” dialog.
[Close] button
When you click this, the “Device Settings” dialog box closes.
This item will be displayed for all devices.