User Manual

Notes
Yamaha LAN Monitor for Mac User Guide
5
Notes regarding a slave with the stack function enabled
Management of a slave, whose stack function has been enabled and the firmware revision is of the following, is not
supported. Note that, even though detection is possible, correct information cannot be displayed.
• SWX3200-28GT/52GT Rev.4.00.15 or earlier
• SWX2310-28GT/52GT Rev.2.04.01 or earlier
• SWR2310-28GT Rev.2.04.01 or earlier
• SWX2310P-28GT Rev.2.02.14 or earlier
Notes on printing and print preview of the “Whole map”
Depending on the number of terminals displayed on the Whole map and the execution environment of this
software, the “Whole map” may not be printed or previewed correctly.
Such issues may be avoided by changing the “Preview size” of the “Whole map” to “A6.”
For details, refer to the description of the preview size of the “Whole map” described in the list (
6) for the “Basic
Settings” dialog box (page 15).
The maximum number of units that can be supported to print with this software is the number of units that can be
printed when the preview size is set to A6.
Notes regarding detection of Dante-enabled devices
If the network adapter selection has been changed after starting Yamaha LAN Monitor, Dante-enabled devices may
not be detected. If Dante-enabled devices cannot be detected, restart Yamaha LAN Monitor.
Also, in the environment where Dante Controller has been installed, select the network adapter in Dante Controller
appropriately and then start Yamaha LAN Monitor.
Notes regarding when using macOS10.15.x or later
In macOS10.15.x or later, do not turn off Wi-Fi.
If Wi-Fi is off, Yamaha LAN Monitor cannot detect the network adapter.