User Manual

ManualsBrandsYamaha ManualsProfessional AudioMTX-serie

Table Of Contents

Information
About Yamaha LAN Monitor
Contents
Terminology
Steps to use the software
Software operating requirements
Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x or later
Installing and uninstalling Yamaha LAN Monitor
- Installation
- Uninstallation
- Installing Dante Controller
- When using Yamaha LAN Monitor as a user other than the user who executed the installer
- When using a computer with WireShark installed
Starting and exiting Yamaha LAN Monitor
- Starting
- Exiting
Yamaha LAN Monitor screen structure
- Making screen layout changes
Network settings on the computer
Basic operation
Menu bar
- [LANMonitor] menu
- [File] menu
- [Setup] menu
- [About] menu
Toolbar and display area
- Network adapter selection pull-down menu
- [IP Address (PC)]
- Screen switching button
- [Device search] button
- [Snapshots] button
- [Notifications] button / “Notification area”
- [History] button / “History” area
- [Whole map] button
- [Dante Controller] button
Map screen
- “Device Details” view
- Tree view
- “Connected Devices” view
List screen
- “Switch / Wireless AP List” tab
- “Firmware Update” tab
- “Config Import/Export” tab
Configuring the device
- “Device Settings” dialog
- Web GUI
Update the firmware
- Update the firmware one by one
- Update firmware on multiple units at once
Import/Export the CONFIG
- Import the CONFIG one by one
- Import CONFIG on multiple units at once
- Export the CONFIG one by one
- Export CONFIG on multiple units at once
Troubleshooting

Import/Export the CONFIG

Yamaha LAN Monitor for Mac User Guide

8. Check the execution results and output the results to a file if necessary.

NOTE

For the execution result of the CONFIG export, please refer to “Execution result of firmware/CONFIG bulk operation”

(page 61).