User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x or later
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Resources
Yamaha LAN Monitor for Mac User Guide
59
Dante-related notifications
The following messages appear if there is a change in a Dante-enabled device.
Messages generated by the snapshot function
The following messages appear when the snapshot function detects a network error, or when snapshot creation
is started. mac indicates the MAC address of the device that is the subject of the message, label indicates the
label identifying the device (does not appear when left blank), n indicates the port number. Messages are not
shown for devices that are not the subject of monitoring by the snapshot function.
Messages generated by the PoE function
The following messages appear when the PoE function detects abnormality in a power supply. mac indicates
the MAC address of the device that is the subject of the message, label indicates the label identifying the
device (does not appear when left blank), q indicates a number that represents the power, n indicates the port
number, portIp indicates the IP address of the device connected to the port, and portMac indicates the MAC
address of the device connected to the port. Messages are not shown for devices that do not support power
supply.
Messages
The word clock of <device name> has been unlocked.
The word clock of <device name> has been locked.
The link is down for the primary port of <device name>. Dante is only working for the secondary port.
The link is down for the secondary port of <device name>. Dante is only working for the primary port.
The link is up for the primary port of <device name>.
The link is up for the secondary port of <device name>.
The Dante module of <device name> is operating in safe mode.
Messages
[mac] label: Device status matches the snapshot.
[mac] label: An unregistered device [mac] label is connected.
[mac] label: [mac] label is not connected to port n.
[mac] label: There is a device with an incorrect connection port. Connect [mac] label to port n.
Create a snapshot.
Started creating a snapshot.
Finished creating a snapshot.
Snapshot creation canceled.
Failed to create a snapshot.
[mac] label: There is a port with an incorrect device connected. Connect [mac] label to port n.
Messages
[mac] label: The power being supplied from Yamaha switch has exceeded the guard-band (q W).
[mac] label: The power that might be supplied exceeds q W. The power being supplied from Yamaha switch might be
interrupted according to the condition.
[mac] label: Yamaha switch has detected down of portIp (portMac).
[mac] label: Yamaha switch has detected portIp (portMac).
[mac] label: Yamaha switch has stopped supplying power to portIp (portMac).
[mac] label: Yamaha switch has started supplying power to portIp (portMac).