User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
122
Placing and connecting the components related to BGM (monaural) input
Here we place and connect the components related to the input of the background music (monaural) that is broadcast to
the facility.
1.
From the “Components” area, drag and drop the following components onto the design
sheet.
• “Matrix Mixer” (8In/4Out)
• “Source Selector” (4Source/1Ch)
• “Fader” (8Ch)
2.
Drag and drop to connect “ANALOG IN” ports 1 through 6 to “Matrix Mixer(2)” input
ports 1 through 6.
3.
Double-click “Matrix Mixer(2).”
The “Matrix Mixer” component editor opens.