User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
157
Placing and connecting the components related to BGM (stereo) output
Here you’ll place and connect the components related to the output of the background music (monaural) that is broad-
cast to the facility.
This is output to the analog output of the MRX7-D.
1.
From the “Components” area, drag and drop the following components onto the design
sheet.
• “PEQ” (8Band/Mono)
• “Fader” (2Ch)
• “ANALOG OUT”
2.
Copy and paste “PEQ(11)” once.
3.
Drag and drop to connect the output port of each “PEQ” to the “Fader(12)” input ports.
4.
Specify “PEQ” and “Fader” as a 2IN/2OUT User Defined Block.
As necessary, change the position, size, and arrangement of the components in the User Defined Block.