User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Introduction
MRX Setup Manual
3
Example 2) Remote conferencing system that also uses Speech Privacy
This is an example where Speech Privacy is used to prevent the discussion content from being leaked outside of the
remote conferencing system room and other external rooms. We’ll assume that there is a single remote location, and
that there are eight mics in the conference room.
This example assumes that you’re using the following equipment.
The number of speakers is not specified. You will also need to provide the appropriate number of cables.
XMV4280
MRX7-D
Analog OUT
Corridor
Meeting room
Microphone 1
Microphone 2
Microphone 3
Microphone 4
Microphone 5
Microphone 6
Microphone 7
Microphone 8
Analog IN
YDIF
Analog IN/OUT
CODEC
etc.
Network Remote A
Main R
Main L
•MRX7-D × 1
• XMV4280 × 1
• iPad with ProVisionaire Touch installed × 1
• CODEC × 1
• Speakers (the number needed)
• SD memory card × 1
• Stereo input ports such as an AUX IN × 2
• Microphones × 8