User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 2) Remote conferencing system that also uses Speech Privacy
MRX Setup Manual
84
Placing and connecting the components related to the mics for output
Here we will place and connect the components related to the conference room speakers, the hallway speakers, and out-
put to CODEC.
Allocate the “ANALOG OUT” 1 to CODEC, the “YDIF OUT” 1 and 2 to speech privacy (hallway speakers), and the
“YDIF OUT” 3 and 4 to the conference room speakers.
1.
Place the components shown below by dragging them from the “Components” area
and dropping them into the Design sheet.
• “Matrix Mixer” (IN=2, OUT=2)
• “PEQ” (MONO, 4BAND)
• “Fader” (1CH)
• “Speech Privacy”
• “PEQ” (STEREO, 4BAND)
• “Fader”(2CH)
• “ANALOG OUT”
• “YDIF OUT”