User Manual
Table Of Contents
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Starting Dante Controller
- Using Dante Controller
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2014 Audinate Pty Ltd. All rights reserved.
-51-
Device View Menu bar
The menu bar in the Device View contains the following menus:
File
n Close Window
Device
n Refresh: Refreshes the displayed network / device data
n Create Multicast Flow
View
n Show/Hide Channel Groups
Help
n About: Shows Dante Controller version and current log file
n License: Displays the license text
n Contents: Opens a help window and displays help contents
Device View Toolbar
The Device View toolbar contains the following buttons:
Refresh Re-load routing and configuration information for
the current device.
Web Config Some Dante devices can be configured via a web
interface. This button opens a web browser
window which can be used to perform functions
such as firmware upgrades. This feature is not
supported on all Dante devices.
Identify Identify the current device by, for example, causing
its LEDs to flash. Note that this feature is not
supported on all Dante devices.
Multicast Configure multicast transmit flows on the current
device.
Channel
Groups
Activates / deactivates Channel Groups.
The toolbar also provides a drop down list of all available devices on the network, which allows you to
switch the Device View to a different device.
Device View Tabs
The Device View is split into tabs, some of which are only applicable to certain devices. Each tab is
described in detail below.