User Manual

“EXi8” screen Chapter 4. System screen

MTX-MRX Editor User Guide

130

“EXi8” screen

Here you can view and edit the parameters of the EXi8 units in the MTX/MRX system. When you

right-click on the display area of a desired EXi8, a context menu appears, allowing you to copy and

paste settings between devices.

1 [EDIT] button

This enables the EXi8 output routing select buttons.

The [EDIT] button is available only in the offline state.

2 EXi8 identification area

Shows the UNIT ID, model type, and model name of the corresponding EXi8 unit.

3 Channel index

Indicates the channel number of the EXi8.

4 [+48V] button

Turns the HA phantom power (+48V) on/off.

Notice

Be sure to leave this button off if you do not need phantom power.

When turning phantom power on, you must observe the precautions below in order to

prevent noise and possible damage to the unit and to external devices.

• Leave this button off if a device that does not support phantom power is connected to the

[INPUT] connector.

• Do not connect/disconnect a cable to/from the [INPUT] connector while this button is

on.

• Lower the output level to the minimum before turning phantom power on/off.

There is no master switch. To avoid malfunctions, be sure to set this appropriately for the

equipment that is connected.

NOTE