User Manual

List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
249
●If [FUNCTION] is [Legacy - MTX Source Select w/sw]
(DCP switches only)
You can control the send on/off for multiple channels via switches, and the send level
for any channel via switches.
If you assign the same source to multiple DCP units and then change the settings on
one of the DCP units, the changes will not be updated on other DCP units. Each DCP
unit will retain the settings (LED status and knob assignments) that were made on it.
❍ [DEVICE]
Select the device that you want to change. These are listed in order of UNIT ID and
model name.
❍ [PARAMETER1]/[PARAMETER2]
In the [PARAMETER1] column, select the target ZONE.
In the [PARAMETER2] column, click  to the left of the channel name to select
ON, OFF, or IGNORE for the desired channels. The ON/OFF/IGNORE setting can
be applied to multiple channels simultaneously. If you select an ON channel, the
bottom half of the dialog box will display the switch-related setting items.
❍ [Assign the send level to:] box
Enables you to assign a function that raises or lowers the send level of the selected
channels to other switches.
❍ [Inc]/[Dec]/[Switch]
Enable you to make settings for the switches specified in the [Assign the send level
to:] box. For details about the settings, refer to If [FUNCTION] is [MTX Send Level
Inc/Dec] for switches.
NOTE