User Manual

Settings for controlling devices across subnets Appendix
MTX-MRX Editor User Guide
266
“Range” shows the IP address setting range.
4 -4. Click the [Apply IP Address] button.
IP addresses are automatically assigned to the virtual devices in the system.
5. Click the [Apply] button.
6. Repeat steps 3 through 5 to assign IP addresses to all virtual devices.
7. When you have finished making settings, click the [OK] button.
Next, use the “IP Address” dialog box to specify IP addresses for the real devices.
When doing so, make settings that match the IP addresses of the virtual devices that were specified
in the “Match Device by IP Address” dialog box.
1. Set the computer’s IP address to “192.168.0.253” and the subnet mask
to “255.255.255.0”.
2. As the device’s settings, set IP SETTINGS to [UNIT ID] or set IP SELECT
MODE / IP Address Mode to [STATIC (IP) (Auto)], set the UNIT ID of all
devices to something other than FD so that none of the devices conflict,
and then power-on the devices.
3. While still offline, click MTX-MRX Editor’s [System] menu item [Device
Information].
The “Device Information” dialog box opens.
4. When all devices are shown in the “Device Information” dialog box,
click the [IP Address] button.
The “IP Address” dialog box opens.