User Manual

“Device Configuration Wizard” dialog box Chapter 3. Project screen

MTX-MRX Editor User Guide

4. Specify the UNIT ID of each device.

Specify the UNIT ID of each assigned device. Set the UNIT ID so that there is no

conflict between devices.

If you selected [New] in the first screen of the wizard, the devices will be numbered

automatically starting from the lowest UNIT ID. If you selected [Edit

Configuration], the currently-specified UNIT ID will be shown. In either case you

are free to make changes.

• [UNIT ID] box

Specify the UNIT ID of the device.

When you click the [UNIT ID] box, the model name of each device of the same type

existing on the network is shown beside its UNIT ID. For devices that do not exist

on the network, only the UNIT ID is shown.

•[YDIF MODE]

Select either [CASCADE] or [DISTRIBUTION] as the connection mode for YDIF

devices.

If there are any YDIF-connected devices other than the MTX, [DISTRIBUTION]

will be selected automatically, and cannot be changed. If there is a single MTX unit,

or if an MRX unit is part of the MTX/MRX system, this will be dimmed and cannot

be changed.

•[Cancel] button

Cancels the operation and exits the wizard.

• [< Back] button

Returns to the previous screen.

Model name is shown