User Manual
Table Of Contents
- 0. Revision History
- 1. Setup
- 2. Command List
- 3. Command Specifications
- 4. Command Sequence
- 5. Meter Value
- 6. Parameter Value Details
- 6.1. Fader parameter
- 6.2. Other parameters (MTX3, MTX5-D)
- 6.3. Other parameters (MRX7-D)
- 7. Parameter List
- 8. Meter List
MTX3/MTX5-D/MRX7-D/XMV Series/EXi8/EXo8 Remote Control Protocol Specications V3.1.0 rev10
9
1. Setup
1.2. Conguring the Remote Controller
MTX3, MTX5-D and MRX7-D can be controlled from an external controller through the Ethernet (NETWORK) connector and RS-232C
(REMOTE) connector.
XMV, EXi8 and EXo8 can be controlled from an external controller through the Ethernet (NETWORK) connector.
The conguration on the remote controller side for each type of connection is shown below.
Ethernet (NETWORK connector) control
IP Address: Specify the IP address of the device you want to control.
IP Port No.: 49280
RS-232C (REMOTE connector) control
Bit Rate: The specied bit rate.
Data: 8 bits
Parity: none
Stop bit: 1 bit
Flow Control : none
RS-232C port pin assignment
Pin Name In/Out Pin Name In/Out
1 NC - 6 DSR In
2 RxD In 7 RTS Out
3 TxD Out 8 CTS In
4 DTR Out 9 NC -
5 GND -
* Pin 4 and Pin 6 are connected internally.
* Pin 7 and Pin 8 are connected internally.