User Manual

3. The basics of using ProVisionaire Design
3.1. Connecting the devices
The connector on the device that will be used to connect to ProVisionaire Design varies depending on the device
model. Refer to the connectors listed in the following table.
DME7 L2 swit ch
ProVisionai re Design
DME7
Net work Port
Model Connector
DME7 Network connector
MTX5-D Dante [PRIMARY]connector
MTX3 Network connector
EXi8/EXo8 Network connector
R series/Tio1608-D Dante [PRIMARY]connector
PC-D/DI series Network connector
XMV-D series Dante [PRIMARY]connector
XMV series Network connector
RM-CG/RM-TT Dante/PoE connector
VXL1-16P Dante/NETWORK connector
3.2. Procedure
To use ProVisionaire Design, proceed as described below, depending on whether the power amp is accessible
nearby.
If you are constructing a Dante network, also install Dante Controller, and do the patching in Dante Controller.
For more about Dante Controller, refer to the links on the Yamaha Pro Audio website.
https://www.yamahaproaudio.com/
3. The basics of using ProVisionaire Design
ProVisionaire Design User Guide | 15