User Manual

■ [Control Change] Tab
Assigns components to control change for each DME. You can change DME parameters by sending control
change messages from external equipment.
You can assign to control change numbers 1-31, 33-95, and 102-119.

Because control change numbers 0 and 32 are used for bank select MSB, numbers 96-101
are RPN/NRPN related, and 120-127 are used for mode messages, they cannot be used for
component assignment.
•
Control Change List
The control change numbers and current settings are displayed in the list in the center.
◦ No.
Displays the control change numbers.
◦ <Ctrl>+drag-and-drop DME parameter into this area.
Indicates the name of registered parameters.
◦ Min/Max
Enables you to specify the editable range of parameters. Click the field to display the operator.
You can change the parameter by dragging the slider.
13. Audio Processors : DME7
168 | ProVisionaire Design User Guide