User Manual

14.7. Dialog box
14.7.1. "MTX Configuration" dialog box
Click on the [MTX Configuration] tool button in the device sheet to open this.
Here you can specify input/output settings, such as MTX input ports, output channels, and matrix buses.

Since these settings are not included in a preset, they cannot be changed via the Preset Recall
function.
•
[INPUT] tab
In this tab, you can make settings related to inputs.
◦ INPUT PORT SETUP
Here you can specify the inputs to the stereo input ports.
STEREO…………. The stereo signal will be input without change.
SUM……………….. The L and R inputs will be summed to a single channel. There will be one input to
the input patch.
◦ INPUT CHANNEL SETUP
Here you can make settings for the input channels.
MONO x2………. The input channels will be treated as two monaural channels.
STEREO…………. The input channels will be treated as a single stereo pair.
•
[OUTPUT] tab
In this tab, you can make settings related to outputs.
◦ MARIX BUS SETUP
Here you can make settings for the matrix buses.
MONO x2………. The input channels will be treated as two monaural channels.
STEREO…………. The input channels will be treated as a single stereo pair.
If the MTX system’s YDIF mode is Cascade mode, the parameters will be shared in common by all
MTX units in the MTX system.
◦ OUTPUT CHANNEL SETUP
Here you can specify the type of output channel speaker processor (1WAYx2 or 2WAY). The
settings here affect the Room EQ and Speaker Processor in the "Output CH" component editor.
14. Audio Processors : MTX5-D/MTX3
ProVisionaire Design User Guide | 183