User Manual

Use [Upper Limit] and [Lower Limit] to specify the range in which the level can be varied. By using
[Parameter Range] you can limit the range in which the user can control the
volume. For example you can use this to specify the maximum volume of background music, or
use a controller to make fine volume adjustments in a narrow range of –6 dB – +6 dB.
•
[MTX Send Level]
The input voltage to the [GPI IN] connector will control the send level of the channel.
If the maximum level cannot be reached because of the length of the cable, adjust the
maximum and minimum input voltage values in the “GPI Calibration” dialog box.
Select one of the following parameter types, and then make the appropriate setting.
◦
Input Ch Send Level
◦
Fx RTN Send Level
■ [GPI Output] dialog box
"Settings" dialog box

For details of Output Type, refer to the DME7 GPI section.
Function
•
[No Assign]
[OUTPUT TYPE] specifies the polarity of the output signal when an alert occurs. No other function are
specified; they will be the default.
◦ [Output Type]
Controls the GPI OUT when a preset is recalled or when a Scheduler event is executed.
•
[MTX ON]
Parameter on/off operations will control the GPI Output.
Select one of the following parameter types, and then make the appropriate setting.
◦
Input Ch ON
◦
Fx RTN ON
◦
ZONE Out ON
◦
Output Ch ON
14. Audio Processors : MTX5-D/MTX3
ProVisionaire Design User Guide | 197