User Manual

Connect the power cords and network cables of the actual devices.
10.
Turn on the power of all connected devices.
Initialize or update the firmware as needed.
For details on initialization or updating the firmware, refer to the owner’s manual of each device.
11.
From the [System] menu on the menu bar, open “Network Setup.”
The "Network Setup" dialog box will appear.
12. Select the network card that will be used for communication with the devices, and click the [OK] button.
13.
The UNIT ID specified for the devices in the "Project" sheet is applied to the devices.
You can use the following methods to change the UNIT ID of a device.
◦
Drag and drop a device from the "Network" area onto the "Project" sheet.
◦
In the "Network" area, click the [Unit ID] button; then while clicking the Identify button in the "Change
Unit ID" dialog box to identify the specific unit, change the UNIT ID manually.
◦
Change the Unit ID using the device. Refer to the Owner’s Manual for the corresponding device.

When you change the UNIT ID, the device restarts.
3. The basics of using ProVisionaire Design
22 | ProVisionaire Design User Guide