User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“YDIF” screen (Distribution mode) Chapter 4. System screen
MTX-MRX Editor User Guide
121
6 Input routing select buttons
These buttons open the “YDIF In Patch” dialog box, where you can select the input
source device and channels for the YDIF signal.
To enable these buttons, click the [EDIT] button.
• These settings are not included in the preset. For this reason, they can be edited only after
clicking the [EDIT] button, in order to prevent the settings from being changed casually.
• This is available only in Distribution mode when the EXi8 is connected via YDIF and the
system is offline.
7 Selection buttons for output signals from the MTX to YDIF
These buttons open the “Channel Select” dialog box where you can select which signals
of the MTX will be output to YDIF channels. These settings are included in the preset.
8 YDIF IN input indicators
These indicators show YDIF input signals for the MTX/MRX unit.
9 Output routing select buttons
These buttons open the “YDIF Out Patch” dialog box where you can select the device
and channels to which the YDIF signal will be output.
To enable these buttons, click the [EDIT] button.
• These settings are not included in the preset. For this reason, they can be edited only after
clicking the [EDIT] button, in order to prevent the settings from being changed casually.
• This is available only in Distribution mode when the XMV is connected via YDIF and the
system is offline.
NOTE
NOTE