User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Channel Select” dialog box Chapter 4. System screen
MTX-MRX Editor User Guide
124
❑ “Channel Select” dialog box
Here you can select the signals that are output from the MTX to YDIF.
If nothing is selected, the signal will not be output to YDIF.
For the MRX, the connection lines in the “MRX Designer” window determine the destination.
• [YDIF:] box
Select the YDIF channel that you want to edit.
•[Thru] button
The signals coming into YDIF input will be sent to the same YDIF channel without
change.
• INPUT CHANNEL (POST ON)
The input channel’s POST signal (after MUTE switching) will be sent to the YDIF
channel.
• STEREO INPUT CHANNEL (POST ON)
The stereo input channel’s POST signal (after MUTE switching) will be sent to the
YDIF channel.
• ZONE OUT
The signal of the zone output will be sent to the YDIF channel.
• OUTPUT CHANNEL
The signal of the output channel will be sent to the YDIF channel.
• [Close] button
Closes the “Channel Select” dialog box.