User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Preset” dialog box Chapter 6. Presets
MTX-MRX Editor User Guide
148
● [Preset Link] button
This displays the “Preset Link” dialog box where you can make settings for linking
preset recall between MTX/MRX systems.
● [Power on Default]
This specifies the preset that will be recalled when you turn on the power of the MTX/
MRX.
If you want the unit to start up with the same settings each time, resetting any changes
that were made, turn this on so that the preset you specified will be recalled at start-up.
Turn this off if the state at the previous shut-down is important, or if the same operator
will be using the system, or if you expect that the power may be turned off during use.
• [OFF]/[ON] toggle button
This is an on/off switch for preset recall at startup.
• Preset select box
This selects the number of the preset that will be recalled when you turn on the
power of the MTX/MRX.
● [Emergency Recall]
This specifies the preset that will be recalled when the MTX/MRX receives an EMG
(Emergency) signal from an external device or when the input to the +24V [GPI IN]
pin (IN 8 for the MTX3, and IN 16 for the MTX5-D and MRX7-D) falls below 2.5V.
• [OFF]/[ON] toggle button
Switches recall on/off. Turn this off if +24V is not being applied to the +24V [GPI
IN] pin.
• Preset box
Selects the preset number that will be recalled.
● [Close] button
Closes the “Preset” dialog box.