User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Settings” dialog box Chapter 6. Presets
MTX-MRX Editor User Guide
150
“Settings” dialog box
Here you can specify the DCP library, Wireless DCP library, MCP1 library, GPI OUT, and
SD memory card settings that will be recalled when the preset is recalled.
[DCP Library]/[Wireless DCP Library]/[MCP1 Library]
Here you can specify the library that will be recalled when the preset is recalled. If the
[Assign] check box is selected, you’ll be able to select a library item. If the [Assign]
check box is cleared, operation from a DCP, Wireless DCP, or MCP1 will not be
possible.
If library data differs between devices, this is indicated by red characters. Store the
corresponding library item once again in the “Digital Control Panel” dialog box, the
“Wireless DCP” dialog box, or the “MCP1” dialog box.