User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Word Clock” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
181
❑ “Word Clock” dialog box
Here you can edit the word clock settings of the MTX/MRX system. Normally, these will be set to
the optimal values when you use the “Device Configuration Wizard” dialog box to create the
configuration. If you want to specify a Mini-YGDAI card as the word clock master etc., make
settings in this dialog box.
● [Preserve the Dante settings configured by Dante Controller]
check box
Select this check box if you’re using Audinate Corporation’s Dante Controller to set up
the Dante network. The settings of Dante Controller will take priority over the settings
made in MTX-MRX Editor. If this check box is cleared, you’ll be able to use MTX-MRX
Editor to make Dante network settings within the project.
● [Auto] button
Sets the word clock and master clock for all MTX/MRX systems in the project. This is
available only when offline.
● System select tabs
These select the MTX/MRX system whose word clock you will set.
● [System Word Clock Fs:] box
This specifies the word clock of the MTX/MRX system.
● [Advanced Setting] button
This switches the display to a screen where you can make advanced settings. The
illustration above shows the state when the [Advanced Setting] button has been clicked.
● [Device] list
This lists the devices whose word clock can be changed. Click the device whose detailed
word clock settings you want to edit; the edit screen for that device will appear. The icon
at the left of the UNIT ID indicates what is specified as the clock source.