User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“GPI Calibration” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
226
❑ “GPI Calibration” dialog box
Here you can calibrate the input voltage detection range for the [GPI] connector of the MTX/MRX
unit. (Available only when online.) These settings adjust the detection range in order to stabilize the
input voltage of the [GPI] connector.
● [Device:] box
Selects an MTX/MRX unit within the MTX/MRX system.
From the left, this shows the “UNIT ID,” “Type (model name of the device),” and
“Device Name (name of the device).”
● Channel select check boxes
Calibration will be applied to the channels whose boxes are selected.
● [All Ports] check box
Selects the check boxes of all channels.
● Calibration data
The input voltage is shown in real time as a graph.
● [Reset] button
Calibration will be reset for the channels whose boxes are selected.
● [Max] button
Sets the current input voltage of the selected channels to the maximum value.
The maximum value you set is shown by a red bar.
● [Min] button
Sets the current input voltage of the selected channels to the minimum value.
The minimum value you set is shown by a blue bar.
● [Close] button
Closes the dialog box.