User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Input Source/Redundant” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
233
❑ “Input Source/Redundant” dialog box
Here you can specify for each channel whether the input source to the XMV will be digital or
analog. If the input source is specified as digital, you can specify that the input source will switch
from digital to analog when a pilot tone or analog input is detected. Here we explain the screen for
when the digital input is YDIF.
● [Redundant Mode] list box
Selects the redundancy method.
•[Off]
Redundancy is not used.
•[Backup]
Switch to analog input when the pilot tone of the digital input is interrupted due to
a broken connection or other problem.
•[Override]
Switch the digital input to the prescribed analog input when analog audio is
detected.
When the YDIF connection of the system including MTX3 or MTX5-D is disconnected, the
analog output audio from MTX3 or MTX5-D will be interrupted periodically due to the
interruption of the word clock signal supply. This event can be resolved by reconnecting the
YDIF connection. This event does not occur on the MRX7-D.
NOTE