User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
MTX-MRX Editor User Guide
236
Appendix
List of settings in “Settings” dialog boxes
This section explains the settings in the following “Settings” dialog boxes.
For details about settings that are unique to the MRX series, refer to “MRX Designer User Guide.”
• DCP/Wireless DCP/MCP1
•GPI Input
• GPI Output
■ DCP/Wireless DCP/MCP1
Settings for the switches and knobs/sliders of the DCP, the Wireless DCP, or MCP1 are
explained here.
● If [FUNCTION] is [No Assign]
Use this setting if you don’t want the switch or the knob/slider of the controller to
change any setting. This is unavailable for [DEVICE] and for [PARAMETER 1/2].
● If [FUNCTION] is [Open Page] (only for the HOME page of the MCP1)
The switch of the MCP1 changes pages of the MCP1.
● If [FUNCTION] is [MTX ON] (switch only)
The switch turns the parameter on/off.
Select one of the following parameter types, and then make the appropriate setting.
•Input Ch ON
•Fx RTN ON
• ZONE Out ON
•Output Ch ON
• Input Ch Mute Group
•ZONE Out Mute Group
In the case of Input Ch Mute Group and ZONE Out Mute Group, the unit’s LED is unlit when
mute is on.
NOTE