User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
262
●If [FUNCTION] is [SD Song Play]
The status of audio file playback will be output to the [GPI OUT] connector.
❍ [DEVICE]
Select the device that you want to change.
❍ [OUTPUT TYPE]
Specifies how output will occur from the [GPI OUT] connector.
● If [FUNCTION] is [Alert]
A signal will be output to the [GPI OUT] connector when an alert occurs.
❍ [DEVICE]
Selects the device whose [GPI OUT] connector will output the alert.
❍ [PARAMETER1]
Select the type of alert from the following.
•Fault, Error, Warning
•Fault, Error
•Fault
For details on the type of alert that is output, refer to “Alert list”.
❍ [OUTPUT TYPE]
Only Closed can be selected. If an alert is occurring, the [GPI OUT] connector will
be closed. The closed state will continue until the alert has been cleared.