User Manual

Settings for controlling devices across subnets Appendix
MTX-MRX Editor User Guide
268
5. Click the [Auto-Assign IP Addresses] button so that the virtual device IP
settings specified in the “Match Device by IP Address” dialog box are
applied to the “IP Address” dialog box.
The “Auto-Assign IP Addresses” dialog box opens.
The IP settings of the virtual devices are shown.
6. If you need to connect to a DNS server, specify the [DNS Server] setting.
7. If there are no problems with the IP settings of all devices, click the
[Assign IP Addresses] button.
The settings are applied to the “IP Address” dialog box.
If there is a problem or if you want to change the settings, click the [Match Device
by IP Address] button, make the settings in the “Match Device by IP Address” dialog
box, and then click the [Assign IP Addresses] button once again.
You can also make IP settings for the real devices manually while referring to the IP
settings of the virtual devices. In this case, in the “IP Address” dialog box, select the
[Use the following IP Address] option button, and then enter the [IP Address] and
[Subnet Mask].
8. In the “IP Address” dialog box, select the device and click the [OK]
button.
The settings are applied to the real device.
9. In the device’s settings, set IP SETTINGS to [PC] or set IP SELECT MODE
/ IP Address Mode to [STATIC IP (MANUAL)], and then restart.
This completes the settings.
If the “Match Device by IP Address” dialog box’s [Match Device by IP Address] check box is
selected, use the IP address to associate the virtual device and real device. If the IP
addresses of the virtual device and the real device are different, the devices are shown both
in the Project screen’s network device area and in the MTX/MRX system’s area, even if the
UNIT ID is the same.
NOTE