User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
Troubleshooting Appendix
MTX-MRX Editor User Guide
276
No sound is
output.
A cable is broken or disconnected.
Check whether the cables between each device are
connected correctly. If the cables are connected correctly,
check whether they might be broken, and replace any that
are broken.
The DIP switches on the unit are
set incorrectly.
Check the setting of the DIP switches on the u nit. In
particular if START UP MODE is set to INIT., there will be no
sound unless the unit synchronizes with MTX-MRX Editor
each time the power is turned on.
The settings in MTX-MRX Editor
are incorrect.
Check the settings of MTX-MRX Editor. In particular for
YDIF, make sure that the “EXT. I/O” settings match the port
settings of the input/output channels.
The XMV is in double power mode.
In double power mode, the B/D/F/H channel output is
disabled. Either cancel double power mode, or use the
Editor to specify a different channel.
Problem Possible cause Action
© 2013 Yamaha Corporation
Published 06/2022 IP-M0