User Manual

Basic use of MRX Designer
MRX Designer User Guide
10
4. From the “Components” area at the left, drag the component that you
want to use and drop it on the design sheet.
If you drop a component that has multiple candidates such as channels, the
candidates are displayed; select the one that you want to use.
• Double-click on a component in the “Components” area to select Stamp mode; in
this mode, components are placed successively each time you click the design
sheet. To cancel Stamp mode, press <Esc> or click any component in the list.
• The input/output jacks of the MRX are not placed in the default state. Place the ports
that you want to use from “Input/Output” in the “Component” area at the left.
5. To make a connection, drag the  of a component and drop it on the 
of another component.
For details, refer to Connecting ports.
NOTE