User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
User Defined Block
MRX Designer User Guide
116
There are three User Defined Block protection modes.
•Off mode
The unprotected state.
• View Only mode
A protected User Defined Block or a component editor inside the block can be
opened, but the configuration and parameters cannot be changed. Components in
the User Defined Block are not shown in the “Parameters” area.
A lock icon ( ) is shown at the lower left of the component editor in a protected
block.
• Protect mode
A protected User Defined Block cannot be opened. Components in the User
Defined Block are not shown in the “Parameters” area. Use this when you want to
keep the content completely concealed.
A lock icon ( ) is shown at the upper left of the protected block.
To apply protection, proceed as follows.
1. Select the User Defined Block that you want to protect.
If you select multiple User Defined Blocks, they will be protected in the same mode.
2. In the “Properties” area, use [Lock Mode] to specify the lock mode that
you want to apply.
3. As necessary, repeat steps 1 and 2 to specify the lock mode for other
User Defined Blocks.