User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
If [FUNCTION] is [MRX Source Select] (DCP/Wireless DCP)
MRX Designer User Guide
139
We will explain the switch settings in this example.
Switch settings
Select the following parameter type to be operated by the switch, and then make various
settings.
•Source Select
•Inc/Dec
❍ [PARAMETER1]/[PARAMETER2]
[PARAMETER1] shows the component that is specified in the “Source Select” tab.
In the case of Source Select, [PARAMETER2] specifies the source that will be turned
on. ON can be specified only for one source.
In the case of Inc/Dec, if the above switch is used to change the source of the “Source
Selector” component, the level-type parameter specified below is assigned to the
switch.
The following parameters can be specified for each source ([each one of
[PARAMETER2]).
❍ [Select Parameter:]
Specify the level-type parameter that will be linked with the selected source. The
[Clear] button clears the parameter.
❍ [Inc]
If you select this, the level is raised each time you press the switch.
✦[Upper Limit]
Specifies the maximum level achieved by pressing the switch.
❍ [Dec]
If you select this, the level is lowered each time you press the switch.