User Manual

Menu bar
MRX Designer User Guide
14
[View]
[Components]
If this item has a check mark, the corresponding
area is shown.
—
[Parameter
Sets]
—
[Parameter
Link Group]
—
[Gang Edit
Group]
—
[Properties] —
[Parameters] —
[Bird’s Eye
View]
Selects the Bird’s Eye view display type.
[Floating] : Shows the Bird’s Eye view in a
separate window from MRX
Designer.
[Docking] : Shows the Bird’s Eye view in the
lower right of MRX Designer.
[Hide] : Hides the Bird’s Eye view.
—
[Zoom In] Magnifies the display within the design sheet. —
[Zoom Out] Shrinks the display within the design sheet. —
[Zoom to
100%]
Sets the display magnification in the design
sheet to 100%
—
[Zoom to Fit]
Adjusts the magnification so that all placed
components can be seen in the design sheet.
—
[Print Aria]
On the design sheet, shows the paper size
specified in the “Print” dialog box. The (x,y)=(0,0)
of the design sheet is the top left of the paper.
—
[Tools]
[Compile]
Analyzes the placement and wiring of the
components in the selected MTX/MRX system to
see whether there are any problems.
“Compile” dialog box
[Snapshot
Group]
Specifies a snapshot group.
“Snapshot Group” dialog
box
[Remote
Control Setup
List]
Registers the parameters that will be controlled
from a remote controller.
“Remote Control Setup
List” dialog box
[Peak Hold]
If ON is checked, the meters of the assigned
component will hold the maximum value.
If you select Reset, the held maximum value is
reset.
—
[Trace Signal
Path]
If you select a port or wire while this is checked,
the signal path is traced toward the output and
toward the input, starting from the selected item.
—
[Duplicate Port
Label]
If you make a connection while this is checked,
the port name of the connection-source is copied
to the connection-destination port.
—
Menu Command Summary
Dialog box or window
that appears