User Manual

About [Unbundle Wires]
MRX Designer User Guide
26
❑ About [Unbundle Wires]
After you have placed all of the necessary components and have finished creating wires between
them, you can select all components and execute [Unbundle Wires] to prevent the wires from
overlapping in the display.
When you execute [Unbundle Wires], the items in the “Properties” area for the components and the
wires connected to the components are set to the following values.
If you want to selectively change the spacing between the wires, perform the operation above, and
then change the [Output Wiring Step] or [Input Wiring Step] values.
If you don’t want wires to overlap when you’re making connections, execute the following procedure.
1. Place all components.
2. Select all components, and execute [Unbundle Wires].
3. Make one connection between components, and select the wire.
4. Set the wire’s [Wire Routing] to [Automatic], and set [Auto Block Avoidance] to
[False].
5. Click the [Save Style] button to save the wire’s user style to the computer.
Subsequently when you connect wires, they are shown without overlapping.
Item Value
Component
Output Wiring Step 10
Input Wiring Step 10
Wire
Wire Routing Automatic
Auto Block Avoidance False