User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
Link Master editor
MRX Designer User Guide
38
❑ Link Master editor
There is a link master for each parameter link group.
When you change a link master parameter, the change also affects the parameters that are registered
to the parameter link group. Even if you change a parameter that is registered to the parameter link
group, the change does not affect the link master parameters.
The name of the parameter link group is shown in the title bar and at the bottom of the editor.
1 Fader (Level-type only)
Specifies the value of a level-type parameter.
2 [ON] button (ON/OFF-type only)
Turns the parameter on/off.
3 [Match Values] button
If [Absolute] or [Equal] is selected in the combo box, this button sets the value of the
registered parameter to be the same as the link master value.
4 [ACTIVE] button
If this is on, the parameter link group is enabled. Turn this off if you want to temporarily
disable the link.
5 Combo box
Specifies how Level-type and ON/OFF-type settings are applied.
LEVEL-type ON/OFF-type
[Absolute]/[Equal]
Sets the value of the registered parameter to the same value as the
link master.
[Relative]/[Opposite]
When you operate the link master, the registered parameters
change while maintaining their relative position.
1
4
5
3
2
4
5
3