User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
“GEQ” component editor
MRX Designer User Guide
74
3 Bypass buttons
Specify whether each band is bypassed. If you click a button to make it light, that band
is bypassed.
4 Gain faders
Adjust the output gain of each band.
5 [±15]/[±12]/[±6]/[–24] buttons
Select the range of GEQ gain adjustment. When you click a button, the display of the
gain faders and EQ curve will change to the range you select.
6 [FLAT] button
Moves all gain faders to the 0 position.
7 [INPUT] meter
Shows the input signal level.
8 [HPF] knob / HPF [BYPASS] button
Specifies the cutoff frequency of the high-pass filter. If you are not using the high-pass
filter, click the [BYPASS] button to turn bypass on (lit).
9 [LPF] knob / LPF [BYPASS] button
Specifies the cutoff frequency of the low-pass filter. If you are not using the low-pass
filter, click the [BYPASS] button to turn bypass on (lit).
0 [B/W-Q] knob
Specifies the width of the frequency band adjusted by the notch filter.
A [Freq.] knob
Specifies the center frequency of the notch filter.
B NOTCH [BYPASS] button
Switches the notch filter bypass on/off. If you are not using the notch filter, turn bypass
on (lit).
C [OUTPUT] meter
Shows the output signal level.