User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
“Pitch Shift FBS” component editor
MRX Designer User Guide
80
If you don’t notice any result, it may be that detection has failed. Click the [CLEAR] button to
discard the detection result. If you want to make the settings once again, adjust the position of
the mics and speakers, adjust the volume, and try the above procedure once again from step 1.
In some cases, detection will not occur correctly if the overall volume is raised excessively, or
if the mics and speakers are too close, or if sound from a speaker is directly entering a mic.
The MRX cannot detect multiple feedback points simultaneously. Settings will be easier if you
raise the fader or gain slowly so that feedback occurs gradually.
“Pitch Shift FBS” component editor
1 PITCH SHIFT FBS [ON] button
Switches the Pitch Shift FBS function between enabled and disabled. Pitch Shift FBS
operation will begin when you turn this on.
2 Mode list box
Selects the type of input signal.
The modes are as follows.
• Speech
Choose this if the input signal is speech.
•Music
Choose this if the input signal is music.
3 [SUPPRESSION LEVEL] knob
Specifies the amount by which feedback is suppressed. Higher values produce a
stronger effect.
4 [Cents]
Indicates the amount of pitch change applied by the effect, in units of cents.
NOTE
HINT
1
2
3
4