User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
“STEREO IN” editor
MRX Designer User Guide
86
4 [+48V] button
Turns the HA phantom power (+48V) on/off.
Notice
Be sure to leave this button off if you do not need phantom power.
When turning phantom power on, you must observe the precautions below in order to
prevent noise and possible damage to the unit and to external devices.
• Leave this button off if a device that does not support phantom power is connected to the
[INPUT] connector.
• Do not connect/disconnect a cable to/from the [INPUT] connector while this button is
on.
• Lower the output level to the minimum before turning phantom power on/off.
There is no master switch. To avoid malfunctions, be sure to set this appropriately for the
equipment that is connected.
5 Port name
Shows or edits the port name. This is linked with the “Label” of the component’s ports.
“STEREO IN” editor
This shows the level of the audio signals that are being input from the [ST IN] jacks.
“YDIF IN” editor
This shows the level of the audio signals that are being input from the [YDIF] jacks.
NOTE